Rope Inc. rope and wire
For All Cordage and Wire Needs
SPLICING
GUIDES

12-Strand Single Braid Eye Splice (Lock Stitch)

(for large size eyes in Regatta Braid, and for NEREX)

 

Step 1

Mark rope in one full fid length from the bitter end. This is mark "A". Measure one long fid section further. This is mark "B". Form the desired eye size and place mark opposite "B". This is mark "C". Continue down the rope an additional 1 and 1/2 fid lengths. This is mark "D". (Fig 1)

Step 2

Work from mark "A" toward the bitter end. Mark the sixth pic and continue marking every 5 pics. Cut and remove these strands back to bitter end and re-tape the bitter end.

Step 3

To mark the tuck points in the area between points "B" and "C", mark the 3rd, 6th, and 9th pics. Open up "B" with a fid tool and pass the bitter end and tail through the rope completely. Pull the tail through until "A" and "B" align. Make subsequent tucks in the same manner between the 3rd and 4th, 6th and 7th strands. (Fig 2)

Step 4

Pull the tucks tight as you go. After the last tuck above, attach your splicing tool to the tail and insert it between the 9th and 10th strand, exiting the rope at mark "D". Remove the tool and the tape wrap from the tail end. Hold the eye firmly and smooth the rope down the standing part. The tail will withdraw into the rope.

Go Back

Rope inc.
262 SW 33rd Street
Fort Lauderdale FL  33315
Tel 888-596-7673
Tel (954) 525-6575
Fax (954) 525-5887