Rope Inc.

Rope Inc social media
Marine Racing Boats Rope

Rope inc. provides Polytec Rope from New England Ropes. Contact Us to quote availabilites and pricing for your racing needs.

See Polytec Rope for racing from New England Ropes supplied by Rope Inc. below.


Poly Tec

Polytec Rope  
View Larger Image

Product Description:
The Poly Tec cover is a blend of Technora and Polyester fibers. Technora offers excellent abrasion and cut resistance, heat dissipation, and a level of grip that other high tech fibers do not offer.


  • Excellent Abrasion Resistance
  • Great Heat Dispensation
  • Excellent Cust Resistance
  • Great Grip


  • Runner Tails
  • Mainsheets
  • Genoa Sheets
  • Spinnaker Sheets

Colors Available:

  • Grey/Blue
  • Grey/Orange
  • Grey/Red
  • Grey/Yellow
  • Grey/Green

Lengths Available:

 3/8 (10mm) 5.4 80.4 15,700 7121

Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Polyester has good resistance to most chemicals, except 95% sulfuric acid and strong alkalines at boil. While Technora has good resistance to most minerals / organics, acids, weak alkalis, bleaches and other oxidizing agents and most solvents.

Polyester melts at 480°F with progressive strength loss above 300°F. Technora melts at 1200' F.

Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Recommended sheave diameter to rope diameter is 8:1.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.


Disclaimer: Specifications and prices are believed accurate but must be confirmed upon ordering.

Contact Us to quote availabilites and pricing for your racing rope needs.
Search this Site!