Rope Inc. rope and wire
For All Cordage and Wire Needs
Dyneema Chafe Sleeve

Racing Lines
Marine Racing Boats Rope

Rope inc. provides Dyneema Chafe Sleeve from New England Ropes. Contact Us to quote availabilites and pricing for your racing needs.

See Dyneema Chafe Sleeve for racing from New England Ropes supplied by Rope Inc. below.


Dyneema Chafe Sleeve

V-12 Rope  
View Larger Image

Product Description:
Dyneema SK 75 48 carrier cover perfect for use with high tech cores or twelve strands (Endura 12, V12 or PBO). Very tough and abrasion resistant, easily taperable for halyard ends.


  • Chafe sleeve for halyards, sheets, guys, and strops

Colors Available:

  • White

 Small (core size 5mm-8mm) Mfg.# 1930-06 0.8 12.5 - -
 Medium (core size 8.5mm-11.5mm) Mfg.# 1930-08 1.3 19.3 - -
 Large (core size 12mm-16mm) Mfg.# 1930-10 2.0 29.8 - -

Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

HMPE has good resistance to most minerals, organics, acids, and weak alkalines. HMPE also has excellent resistance to bleaches and other oxidizing agents and to most solvents.

HMPE melts at 300°F with progressive strength loss above 150°F.

Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Recommended sheave diameter to rope diameter is 8:1.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
Not Applicable


Disclaimer: Specifications and prices are believed accurate but must be confirmed upon ordering.

Contact Us to quote availabilites and pricing for your racing rope needs.
Search this Site!

Click A Flag For Translation


Rope inc.
262 SW 33rd Street
Fort Lauderdale FL  33315
Tel 888-596-7673
Tel (954) 525-6575
Fax (954) 525-5887