Rope Inc. rope and wire
For All Cordage and Wire Needs
Megabraid II Nylon Rope

Marine Boats Anchoring Rope

Rope inc. provides Megabraid II Nylon Ropes from New England Ropes. Contact Us to quote availabilites and pricing for your anchoring needs.

See Megabraid II Nylon Ropes for anchoring from New England Ropes supplied by Rope Inc. below.


Mega-Braid II

Mega-Braid II  
View Larger Image

Product Description:
Most abrasion resistant 12-strand on the market. Each of Mega-Braid II's 12 strands are individually braided resulting in an extremely firm yet flexible rope that resists picking and chafing. Can be used in many powered windlasses.

Get Price


  • Abrasion Resistant
  • Flexible and easy to handle
  • Works in many powered windlasses


  • Anchor lines
  • Dock lines

Colors Available:

  • White

Lengths Available:

  • 600'

 1/2" (12mm) 6.0 89.3 6,800 3,085
 9/16" (14mm) 7.2 107.1 8,000 3,630
 5/8" (16mm) 9.8 145.8 10,000 4,540

Very little degradation from sunlight. Can be used outside over long term if inspected regularly.

Nylon will degrade with strong oxidizing agents, mineral acids, and 90% formic acid. May discolor when exposed to high levels of carbon dioxide.

Nylon melts at 460°F with progressive strength loss above 300°F.

Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.

Recommended sheave diameter to rope diameter is 8:1.

Working Loads:
No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.

Splicing Instructions:
12-Strand Eye Splice - Bury

Product Datasheet
Product Information


Disclaimer: Specifications and prices are believed accurate but must be confirmed upon ordering.

Contact Us to quote availabilites and pricing for your boating rope needs.
Search this Site!

Click A Flag For Translation


Rope inc.
262 SW 33rd Street
Fort Lauderdale FL  33315
Tel 888-596-7673
Tel (954) 525-6575
Fax (954) 525-5887