New England Ropes Premium 3-Strand Filament Nylon rope is manufactured using premium grade, high tenacity, coated nylon fibers. Resulting in a longer wearing, flexible and easy-to-handle rope; that has greater strength and better abrasion resistance than other three strand nylon ropes. Ideal for uses requiring high-energy absorption.
Compliance to the above specifications is based upon testing according to the Cordage
Institute Standard Testing Methods for Fiber Rope and/or ASTM D-4268 Standard Methods of
Testing Fiber Ropes.
Weights - Are average and may vary +/- 5%
Tensile strengths - Are approximate average for new, unused ropes. To estimate the minimum tensile strength of a new rope, reduce the approximate average by 15% (Cordage Institute defines minimum tensile strength as two standard deviations below the average tensile strength of the rope).
Very little degradation from UV. Can be used outside over long term if inspected regularly.
Good resistance to most minerals / organics, acids, weak alkalis, bleaches and other oxidizing agents and most solvents.
Melting point of 480°F, progressive strength loss above 300°F.
Good resistance to the passage of electrical current. However in rope form, dirt, surface contaminants, water entrapment and the like can significantly affect dielectric properties. Extreme caution should be exercise any time a rope is in the proximity of live circuits.
Recommended D/d ratio is 8:1
No blanket working load recommendation can be made because it depends on the
application and conditions of use, especially potential danger to personnel. It is
recommended that the user establish working loads and safety factors based on professional
and experienced assessments of risks. The working load is a guideline for the use of a
rope in good condition for non-critical applications and should be reduced where life,
limb, or valuable property is involved, or exceptional service such as shock, sustained
loading, severe vibration, etc. The Cordage Institute specifies that the Safe Working Load
of a rope shall be determined by dividing the Minimum Tensile Strength by the Safety
Factor. Safety factors range from 5 to 12 for non-critical uses, 15 for life lines.
SLK= Minimum Break Strength / Safety Factor
White, Black (Red tracer)
Available in standard 600, and 1200 ft lengths
3-strand Eye Splice
Fabricated Units can be provides including splices, thimbles, integral chafe sleeves, etc. Contact Customer Service for details.
Rope Products Hm.
|262 SW 33rd Street|
|Fort Lauderdale FL 33315|
|Tel (954) 525-6575||Fax (954) 525-5887|